top of page
REVO 5-axis
REVO 5-axis

A REVO® system delivers high performance scanning, non-contact inspection and surface finish analysis on a single CMM.

The REVO system uses synchronised motion and 5-axis measurement technology to minimise the dynamic effects of CMM motion at ultra high measurement speeds.

This is achieved by letting the REVO-2 head do the fast demanding motion while the CMM moves in a linear slow fashion. The use of a flexible tip-sensing probe further adds to the system's accuracy and performance. The removable probe system, used in conjunction with a low cost changer, provides added system flexibility.

Speed, accuracy, agility

As a new installation or an accredited upgrade, the REVO 5-axis measurement system offers:

Surface finish measurement and dimensional inspection.
15% to 50% cycle time savings.
Maximised throughput, minimised capital investment.

Faster calibration

Calibration on traditional CMM systems consumes a considerable amount of time that could otherwise be used for part measurement. Using a table mounted sphere, the simple and practical calibration technique for REVO-2 determines the actual head and probe geometry, allowing measurement in any position from a single operation.

Where a CMM is used only for a single or limited number of parts, typically there may be 10 head orientations used. Calibration time for these positions may take around 30 minutes. REVO-2 requires only 20 minutes.

If the CMM is used for multiple parts, typically there may be 40 head orientations, dramatically increasing the time required for calibration to around two hours. Again, REVO-2 requires only 20 minutes.

As the calibration process is repeated on a regular basis, to comply with quality procedures or following a probe crash, these time savings accumulate.

REVO 5-axis

Catalogue

All content on this page is copied from the original website

www.

bottom of page